一、易于安裝等特點為了保障攪拌站的操作人員的安全,建議安裝壓力安全閥,這個是安全的最后的保障!產品基本屬性: 產品型號Product modelFY-24FY-24過濾面積Filtration area24平方米24Sqm濾芯數量Cartridge number14支14排風量Exhaust volume> 1500 立方米/小>1,500 m3/ h過濾效率Filtration efficiency> 99.9%> 99.9%清理方式Clearance間歇式振動式清灰Vibrated cleaning振動電機功率Vibrated motor power150瓦(380 伏 / 50 Hz)150W (380V / 50 Hz)結構形式Structure圓筒形Cylinder直徑Diameter800 mm800 mm安裝高度Installation height1655mm1655mm連接方式Connections卡箍連接(含密封圈)Clamps (including seal)桶體材料Body material碳鋼Carbon Steel噴漆顏色Paint color黃色Gray / Yellow (optional)重量Weight100kg100kg
二、濾芯清洗方式每6 個月一次, 取出濾芯進行清洗。Once every six Remove filter cleaning.清洗可采用壓縮空氣或者高壓蒸汽(最高溫度不得超過80 0C),Use compressed air or high pressure steam cleaning(the maximum temperature of over 80 0C).在濾芯外側40 厘米距離處進行噴洗。從濾芯頂部慢慢移向底部。In the filter lateral distance of 40 cm for jet washing.Gradually shift from the top of the bottom of the filter.清洗結束后, 將濾芯開口朝下以便水份流出。After washing, opening facing down so that water willfilter out.室溫下放置約一周待其晾干。Once dry place at room temperature for about a week.或者在烘箱內(最高溫度不得超過80 0C)烘大約20 小時可干。Or in the oven (the maximum temperature of over 800C) to try to be out of work for about 20 hours.
三、. 維護Maintenance每 3 個月一次, 檢查除塵器內部的潔凈部位是否有粉塵出現;如果出現粉塵, 則:1. 檢查濾芯是否破損;2. 檢查密封部位;3. 檢查濾芯是否正確安裝在安裝板上。Once every three months to checkwhether a dust precipitator internalparts of the cleanliness there.If dust :1. Check whether the damaged filter;2. Seal inspection sites;3. Check whether the correct installation ofthe filter installed board.